BUILD FRAME PART 1


Inside the box you’ll get:
the manual
4 arms
a yellow orientation ball
some screws
all the fiberglass plates
some rods to hold the ball
a plastic screwdriver
some black hex threaded spacers for the flight controller
landing gear
and the box (obviously).


Now that we have everything out of the box, we can start by screwing the arms on to the bottom plate for the frame (I’m using a 2.0mm hex driver). on the bottom side, each arm only requires 2 screws (so 8 screws total for the bottom).


After that we can flip the frame over screw the top plate on. This process is almost the same but instead of 8 screws, there are 16.


now we can install the mounting plates for the motors, they require 3 screws each.


We’re almost done with the frame, all we have to do now is mount the landing gear. There are only 2 screws for each arm (1 on each end).

0 comments: